Reference Node
In circuits, we usually label a node as the reference node also called ground and define the other node voltages with respect to this point. The reference node has a potential of  0 V by definition. The following symbol is used to indicate the reference node:

The Reference Node Symbol
The Reference Node Symbol


As mentioned, the selection of the reference node is arbitrary. However, a wise selection can make the solving easier. As a general rule, it is usually chosen to be

  • a node with largest number of elements connected to it, or
  • a node which is connected to the maximum number of voltage sources, or
  • a node of symmetry.


Node Voltages
The voltage drop from a node to the reference node (ground) is called the node voltage. To keep definition simple, node voltages are usually defined with positive polarities.

Let’s find label node voltages in the following circuit:
A 5-Node Resistive Circuit

The circuit has 5 nodes:
The circuit has 5 nodes

Two of the nodes have 4 elements connected to them. These are the best candidates to be reference point.
Candidates for reference nodes

Let’s label one as reference node.
Label the reference node

Now, we define node voltages for the remaining nodes. These node voltages represent the voltage between the node and the reference.
Labeling node voltages

When there is a voltage source between a node and the reference node, the node voltage corresponds exactly to the voltage of the voltage source. In our example, we have two node voltages. The  -5 V voltage source is placed between the reference and the node labeled as  V_1. Therefore,  V_1=-5 V.

If there is a voltage source between two nodes, the difference between the corresponding node voltages equals to the voltage of the source. In our example, the  10 V voltage source is located between nodes labeled by  V_2 and  V_4. Therefore,  V_2 - V_4= 10 V. It is important to note that voltage of the positive node minus the one of negative node is equal to the voltage of the source. KVL can be used to show this:
Voltage source between tow nodes

KVL around the loop:  -V_2+(+10)+V_4=0 to V_2-V_4=10 V. Recall that the reference node is always defined to be the negative polarity of all node voltages.

Published by Yaz

Hi! Yaz is here. I am passionate about learning and teaching. I try to explain every detail simultaneously with examples to ensure that students will remember them later too.

Join the Conversation

10 Comments

  1. Thanks a lot for this useful information in my book there is no rule how to choose the reference node 🙂

  2. this is so much better than my teachers explanations and my books, thank you so much! keep them coming!

  3. how to assume the directions of flow of current ? does the wrong assumption of directions of current will affect my calculation of node voltages???????????? reply A.S.A.P

  4. Hi to every body, it’s my first pay a visit of this webpage; this webpage includes awesome and really fine stuff designed for visitors.

  5. thank you soo much for all these informations………….thanks a lot………also tell me rule that how choose nodes in a circuit ???

Leave a comment

Leave a Reply to tony Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.